Forms and Publications

Enter all or part of a document title, description or number:     

Browse By Subject  |  Most Requested  |  Required L&I Workplace Posters  |  Spanish Language Documents  |  Show all L&I Forms/Pubs


Results for: structural
View:    Sort by:       
Title/Description:

Keyword search within results:  
Type:

Structural Inspection Request Questionnaire

Structural Inspection Request Questionnaire



Form
F622-075-000
 
Roof Affidavit and Structural Inspection Request

The purpose of the manufactured home roof affidavit is to provide timely inspections and communications between the contractor and/or owner and FAS inspectors and field staff.

A structural inspection request questionnaire will not be required when a roof change out occurs if no structural changes are made in the roof sub-surface and roof cavity. Example: Repairing or replacing the roof trusses, rafters, ridge beam and the replacement of not more than (4) 4’x 8’ of roof sheathing.



Form
F622-076-000
 
Minimum Header Structural Requirements for Manufactured Home Alterations

For use on sidewalls only. Maximum of one new opening up to 11-6 wide per sidewall. Edge of opening to be no closer than 4 from end of sidewall.



Form
F622-080-000
 
Chapter 296-807 WAC - Portable Power Tools

Portable power tools applies to hand-held power tools; circular saws, belt sanding machines, compressed air powered tools, powder actuated fastening systems designed to use the expanding gases from a powder load to propel a stud, pin, fastener, or other object into hard structural material, consumer and commercial power lawnmowers, portable hand- or power-operated hydraulic, mechanical ratchet and mechanical screw jacks.



Manual
F414-089-000
 





End of main content, page footer follows.

Access Washington official state portal

© Washington State Dept. of Labor & Industries. Use of this site is subject to the laws of the state of Washington.