News | Communication Services, 360-902-5400 - PublicAffairs@Lni.wa.gov

Klickitat County lumber company fined nearly a quarter of a million dollars after worker gets caught in machinery

See more More news releases

September 17, 2013

Tumwater – The SDS Lumber Company of Bingen, Wash., has been fined $244,600 for 69 workplace safety and health violations after a worker was seriously injured in March. The Department of Labor & Industries (L&I) cited the employer for one willful, 54 serious and 14 general violations of safety and health rules.

L&I determined that a lack of training and proper safety procedures left the lumber mill worker with severe injuries when his arms became entangled in machinery while trying to clear a jam.

A willful violation is cited when L&I alleges that the violation was committed with intentional disregard, plain indifference, or when employers substitute their own judgment for safety and health regulations.

L&I began an investigation on March 9 after being notified that the worker had been hospitalized. By law, all employers are required to report to L&I within eight hours anytime a worker is hospitalized or dies due to work-related causes.

"This incident shows the importance of Washington's hospitalization reporting rule," said Anne Soiza, assistant director for L&I's Division of Occupational Safety and Health. "In most other states, a hospitalization involving only one worker does not have to be reported and the serious hazards could continue unabated. In our state, we are able to send inspectors right away to ensure the safety of the other workers."

The investigation found that managers and supervisors were aware that workers routinely bypassed machinery safety guards to try and clear jams while the machinery was still in motion.

Consequently, the company was cited the maximum penalty allowed by law, $70,000, for a willful violation. Additionally, because the willful violation was associated with a worker's serious injuries, the company will now be part of the Severe Violator Enforcement Program, an OSHA program that monitors severe safety violators.

The injury incident prompted comprehensive safety and health inspections of the entire plant. In addition to the machinery violations, the department found serious hazards related to chemicals, hazardous and flammable substances, bloodborne pathogens, confined work spaces, electrical and fall protection.

Many of the violations were corrected during the inspections.

The company has appealed the citations. Copies of the citations are available upon request.

For media information: Elaine Fischer, L&I Public Affairs, 360-902-5413

Connect with L&I: Facebook (facebook.com/laborandindustries) and Twitter (twitter.com/lniwa)

Broadcast version:

A Klickitat County lumber company has been fined $244,600 for 69 workplace safety and health violations after a worker was severely injured in March. A state Department of Labor & Industries' investigation found that a lack of training and proper safety procedures resulted in the worker's arms becoming entangled in moving machinery while trying to clear a jam. The investigation found that supervisors were aware that workers routinely bypassed machinery safety guards to clear jams while the machinery was still in motion. As a result, the company was cited the maximum penalty allowed by law, $70,000, for one willful violation. Subsequent inspections of the entire plant identified a total of 69 violations of safety and health regulations. The company has appealed the citations. Learn more at www dot LNI dot WA dot GOV.

End of main content, page footer follows.

Access Washington official state portal

© Washington State Dept. of Labor & Industries. Use of this site is subject to the laws of the state of Washington.